Mass Spectrometry & Spectroscopy

Analysis of Acetaldehyde and Limonene in Recycled PET Using an HS-GC/MS System

Apr 12 2023

Author: Sonja Wischnewsky on behalf of Shimadzu Europa GmbH

Free to read

This article has been unlocked and is ready to read.

Download

One environmental problem threatening the Earth is plastic waste. Packaging waste accounts for 20-30% of household waste by weight and 60% by volume.
In particular, due to the light weight and durability of polyethylene terephthalate (PET), which is widely used for beverage bottles and various other containers, various methods for reusing PET are being considered. In Japan, 96.7% of PET bottles are collected and 88.5% are recycled, on the other hand, only about 40% are recycled in Europe and about 20% in the United States [1].
For recycling PET, recycling companies in Japan have been implementing their own quality measurements. One example is a method based on using a gaschromatograph massspectrometer (GC-MS) system. GC-MS systems can be used to identify component peaks for qualitative and quantitative analysis of target substances, even for samples that contain many contaminants that make identification difficult.
It is known that acetaldehyde can easily remain in PET containers that contained water beverages, and limonene that contained citrus-based beverages. This article describes an example of using a GCMS-QP™ 2020NX system with a HS-20 NX unit (Figure 1) for qualitative and quantitative analysis of acetaldehyde and limonene in PET bottles.

Sample Preparation

Six types of samples with different pretreatment states were prepared. Sample types included pellets and freeze-ground pellet powder obtained from a recycler, two types of PET bottles that contained commercially marketed bottled water, and one PET bottle type each that contained lemon tea and orange juice. Each type of sample was sealed inside an HS vial. The state and quantity of each sample are indicated in Table 1.


Analytical conditions

The conditions for GCMS analysis with HS are listed in Table 2.

Sample Preparation

Calibration curves were prepared by successively diluting samples with acetone solution to seal 2, 20, 100, and 200 μg quantities of acetaldehyde and 20, 100, and 200 ng quantities of limonene in headspace sample vials, and analysing them based on the analytical conditions indicated in Table 2. Calibration curves for acetaldehyde and limonene are shown in Figures 3 and 4 respectively.

Analysis results

Table 3 lists the quantities of acetaldehyde and limonene per gram of sample that resulted from analysing the sample quantities sealed in the respective vials.

Conclusion

Acetaldehyde and limonene in recycled PET material were successfully analysed qualitatively and quantitatively using an HS-GCMS system. From some of the commercial PET bottle samples, terpinene, a substance similar to limonene, was detected by qualitative analysis at a retention time adjacent to that of limonene.
The results show that the freeze-ground powdered state generally extracted a larger quantity of components into the headspace than the pellet state due to the larger surface area of powder.
Thus, the results indicated that HS-GCMS analysis offers an effective technique for confirming the quality of recycled PET plastics.

References

1. The Council for PET Bottle Recycling
https://www.petbottle-rec.gr.jp/english/

 

Free to read

This article has been unlocked and is ready to read.

Download


Digital Edition

Chromatography Today - Buyers' Guide 2022

October 2023

In This Edition Modern & Practical Applications - Accelerating ADC Development with Mass Spectrometry - Implementing High-Resolution Ion Mobility into Peptide Mapping Workflows Chromatogr...

View all digital editions

Events

analytica 2024

Apr 09 2024 Munich, Germany

Korea Lab 2024

Apr 23 2024 Kintex, South Korea

Korea Chem 2024

Apr 23 2024 Seoul, South Korea

AOCS Annual Meeting & Expo

Apr 28 2024 Montreal, Quebec, Canada

SETAC Europe

May 05 2024 Seville, Spain

View all events